RM新时代官方-首页

What problems should be paid attention to in running in period of concrete mixer?

混凝土攪拌車主要是由專用車底盤、上裝罐體及液壓系統等組成，近幾年受房產業的影響，攪拌車的使用越來越多，因為攪拌車屬于專用車，在操作上跟其它車輛還是有區別的，尤其是新買的攪拌車在磨合期需要十分注意，下面就給大家介紹一下混凝土自動上料攪拌車在磨合期需要注意哪些問題。

The concrete mixer truck is mainly composed of special vehicle chassis, top loading tank body and hydraulic system, etc. in recent years, affected by the real estate industry, the use of mixer truck is more and more. Because the mixer belongs to special vehicle, it is different from other vehicles in operation, especially the newly purchased mixing truck needs to pay attention to during the running in period. The following will introduce the concrete automatic feeding and mixing What problems should be paid attention to during the running in period.

1. 新購買的混凝土攪拌車，使用半個月之后就需要緊固整車的螺栓，特別是連接副梁和底盤之間的“U型”螺栓，其次是減速機與罐體之間的螺栓，緊固時，擰緊力矩應達到300-350Nm。

1. The newly purchased concrete mixer truck needs to tighten the bolts of the whole vehicle after half a month's use, especially the "U-shaped" bolt connecting the auxiliary beam and chassis, followed by the bolt between the reducer and the tank body. When tightening, the tightening torque should reach 300-350nm.

2. 液壓系統也是非常重要的，液壓系統在初次使用250小時后一定要更換高壓抗磨液壓油，以后每使用2500小時就要更換一次，但是換油的時間多不得超過一年，換油的同時盡量更換散熱器濾芯。

2. The hydraulic system is also very important. The high-pressure anti-wear hydraulic oil must be replaced 250 hours after the first use of the hydraulic system. In the future, it must be replaced every 2500 hours, but the oil change time shall not exceed one year at most. The radiator filter element shall be replaced as much as possible when changing the oil.
               

3. 減速機初次使用250小時要更換重負荷的齒輪油，以后每隔2500小時更換一次，但是換油時間不得超過一年。

3. The heavy-duty gear oil should be changed after the reducer is used for 250 hours for the first time, and then every 2500 hours, but the oil change time shall not exceed one year.

4. 在混凝土自動上料攪拌車的正常使用過程中，當散熱器真空表讀數超過0.03兆帕時，應立即更換液壓油和濾芯。

4. In the normal use of the concrete automatic loading mixer, when the radiator vacuum gauge reading exceeds 0.03 MPa, the hydraulic oil and filter element should be replaced immediately.

5. 散熱器溫控開關是自動控制風扇的運轉和停止的，不要隨意的調動。連接底盤和液壓泵之間的傳動軸應每周加注鋰基脂潤滑油。

5. The radiator temperature control switch automatically controls the operation and stop of the fan. Do not adjust it at will. The transmission shaft between chassis and hydraulic pump should be filled with lithium grease every week.

6. 混凝土攪拌車攪拌罐每次卸完料都必須清洗罐體內外及進出料裝置，以防罐內粘過多的混凝土，一般在三個月左右就要進行一次徹底的清理。 攪拌罐導軌與托輪之間的接觸面每周需要加注鋰基脂潤滑油。 罐體檢查孔，就是“人孔”用于罐體內部維修的，必要時，可打開放出罐內的預拌混凝土。

6. The inside and outside of the tank and the feeding and discharging devices must be cleaned every time the concrete mixing tank of the concrete mixer is unloaded, so as to prevent excessive concrete sticking in the tank. Generally, a thorough cleaning is required in about three months. The contact surface between the guide rail and the supporting wheel of the mixing tank needs to be filled with lithium grease every week. The manhole is used for the internal maintenance of the tank. If necessary, the ready mixed concrete in the tank can be opened and discharged.

7. 托輪、卸油轉軸、操縱系統等主要部件每周都需要加注鋰基脂潤滑油，保證其靈活性。

7. The supporting wheel, oil unloading shaft, control system and other main parts need to be filled with lithium grease every week to ensure their flexibility.

以上就是混凝土自動上料攪拌車磨合期需要注意的問題介紹，希望對大家有所幫助，如您想要了解更多資訊內容敬請關注我們的網站。

The above is the introduction of the problems that need to be paid attention to during the running in period of the concrete automatic feeding mixer. I hope it will help you. If you want to know more about the content, please pay attention to our website.