RM新时代官方-首页

攪拌一體車跟其它車輛一樣也是需要保養的，保養要從細節做起，平時在使用的過程中就需要細心，那具體需要注意哪些事項呢？

Like other vehicles, the mixer truck also needs maintenance. The maintenance should start from the details. Usually, you need to be careful in the process of use. What should you pay attention to?

1.一般新購買的攪拌車，在使用一兩周后就需要緊固整車的螺絲，特別是連接副梁和底盤之間的“U型”螺栓，其次是減速機與罐體之間的螺栓，緊固時，擰緊力矩應達到300-350Nm。

1. Generally, newly purchased agitators need to tighten the screws of the whole vehicle after a week or two of use, especially the "U" bolts connecting the auxiliary beam and chassis, followed by the bolts between the reducer and the tank. When tightening, the tightening torque should reach 300-350Nm.

2.液壓系統初次使用250小時后一定要更換高壓抗磨液壓油，以后每使用2500小時更換一次，但換油時間做多不得超過一年，換油的同時好更換散熱器濾芯。

2. After the hydraulic system is used for 250 hours for the first time, the high-pressure anti-wear hydraulic oil must be replaced. After that, it must be replaced every 2500 hours, but the oil change time should not exceed one year. The radiator filter element should be replaced at the same time.

3.減速機初次使用250小時要更換重負荷齒輪油，以后每2500小時更換一次，但換油時間不得超過一年。

3. The heavy load gear oil shall be replaced after the reducer is used for 250 hours for the first time, and then every 2500 hours, but the oil change time shall not exceed one year.

4.正常使用過程中，當散熱器真空表讀數超過0.03MPa時，應立即更換液壓油和濾芯。

4. During normal use, when the radiator vacuum gauge reading exceeds 0.03MPa, replace the hydraulic oil and filter element immediately.

5.散熱器溫控開關是自動控制風扇的運轉和停止，請不要隨意扳動。

5. The radiator temperature control switch automatically controls the operation and stop of the fan. Please do not pull it at will.

6.連接底盤和液壓泵間的傳動軸應每周加注鋰基脂潤滑油。

6. The transmission shaft connecting the chassis and the hydraulic pump shall be filled with lithium base grease every week.

7.攪拌一體車的攪拌罐每次卸料完畢都須進行內部清洗，以防罐內粘灰，少三個月進行一次清理。

7. The mixing tank of the mixer truck must be internally cleaned after each discharge to prevent ash sticking in the tank, which shall be cleaned at least once every three months.

8.罐體檢查孔，就是“人孔”用于罐體內部維修的，要時，可打開放出罐內的預拌混凝土。

8. The tank inspection hole is the "manhole" used for the internal maintenance of the tank. When necessary, it can be opened to release the ready mixed concrete in the tank.

9.攪拌罐導軌與托輪之間接觸面每周需要加涂鋰基脂潤滑油。

9. The contact surface between the guide rail and the supporting wheel of the mixing tank shall be coated with lithium based grease every week.

10.托輪每周需要加注鋰基脂潤滑油。

10. The supporting wheel shall be filled with lithium base grease every week.

11.卸油轉軸每周加注鋰基脂潤滑油。

11. The oil unloading shaft shall be filled with lithium base grease every week.

12.攪拌一體車的操縱系統每周加注鋰基脂潤滑油，保證操縱靈活。

12. The control system of the mixer truck shall be filled with lithium base grease lubricating oil every week to ensure flexible operation.

以上攪拌車的12個事項要充分了解到，這樣才能更好的在施工中順利使用，您有什么問題沒理解就來我們網站http://m.jackpetty.net咨詢吧！

We should fully understand the above 12 items of mixer truck, so that it can be used smoothly in construction. If you have any questions, please come to our website http://m.jackpetty.net Consult!