RM新时代官方-首页

The transmission of the automatic feeding mixer is also a very important part. How should we detect the oil level and oil quality in the transmission?

在對變速器進行檢查或故障診斷前，要對變速器油面和油質進行檢查。把選擋手柄放在P位，將發動機在怠速時少運轉數分鐘，油液達到正常工作溫度，汽車必須停放在水平路面上，這樣才能確保在差速器和變速器之間的油面高度正常、穩定。

Before checking or troubleshooting the transmission, the transmission oil level and oil quality should be checked first. Put the selector lever in position P, run the engine for at least several minutes at idle speed, and the oil reaches the normal working temperature. The vehicle must be parked on the horizontal road, so as to ensure the oil level height between the differential and the transmission is normal and stable.

帶油位標尺的自動變速器油位檢查的具體方法如下：

The specific methods for the oil level inspection of automatic transmission with oil level gauge are as follows:

1、將自動上料攪拌車停放在水平地面上，并拉緊手制動。

1. Park the automatic feeding mixer on the horizontal ground and tighten the hand brake.        

2、讓發動機怠速運轉數分鐘。

2. Allow the engine to idle for several minutes.

3、踩住制動踏板，將操縱手柄撥倒擋、前進擋等位置，并在每個擋位上停留幾秒鐘，使液力變矩器和所有換擋執行元件中都充滿液壓油。然后將操縱手柄撥停車擋位置。

3. Press the brake pedal, move the joystick to the reverse and forward gears, and stay in each gear for a few seconds to fill the hydraulic torque converter and all gear shifting actuator with hydraulic oil. Then, move the joystick to the park position.

4、從加油管內撥出自動變速器油尺，將擦干凈的油尺全部插入加油管再拔出，檢查油尺上的油面高度。

4. Pull out the automatic transmission oil dipstick from the filler pipe, insert all the clean dipstick into the filler pipe and pull it out. Check the oil level height on the dipstick.

本文由自動上料攪拌車整理提供，感謝您的閱讀，希望以上內容對您有所幫助，如您想了解更多精彩內容請點擊我們的官網：http://m.jackpetty.net。

This article is provided by the automatic feeding mixer. Thank you for reading. I hope the above content will help you. If you want to learn more wonderful content, please click our official website: http://m.jackpetty.net .