全自動攪拌車的機器怎么保護？
概述：1 底片機將軸承完全加載，因此良好的光滑度是軸承壽命的主要因素。它直接影響機器的使用壽命和正常運行時間。因此，有必要清洗注入的滑油，
1.底片機將軸承完全加載，因此良好的光滑度是軸承壽命的主要因素。它直接影響機器的使用壽命和正常運行時間。因此，有必要清洗注入的滑油，本機的一次注油點（1）滾動軸承（2）滾動軸承（3）所有齒輪（4）可動軸承，滑動面密封應良好。
1. The negative film machine fully loads the bearing, so good smoothness is the main factor of bearing life. It directly affects the service life and normal operation time of the machine. Therefore, it is necessary to clean the injected lubricating oil. The sliding surface of the primary oil injection point (1) rolling bearing (2) rolling bearing (3) all gears (4) movable bearings of the machine shall be well sealed.
2.新設備的車輪容易松動，應經常檢查。
2. The wheels of new equipment are easy to loosen and should be checked frequently.
3.注意機器的各個部分是否正常工作。
3. Pay attention to whether all parts of the machine work normally.
4.注意磨損零件的磨損程度，并隨時更換磨損零件。
4. Pay attention to the wear degree of worn parts and replace worn parts at any time.
5.放置移動設備的機架平面上的灰塵和其他灰塵，以防止當機器遇到堅不可摧的材料而造成嚴重事故時，可移動軸承在機架上移動。您需要確保沒有對象。
5. Place the dust and other dust on the frame plane of the mobile equipment to prevent the movable bearing from moving on the frame when the machine encounters indestructible materials and causes serious accidents. You need to make sure there are no objects.
6.必須升高軸承油的溫度并立即停車以確認原因并。
6. The temperature of bearing oil must be raised and the machine must be shut down immediately to confirm the cause and eliminate it.
7.如果在滾動齒輪工作時發生碰撞，應立即停放，檢查并碰撞。
7. In case of collision during rolling gear operation, stop immediately, check and eliminate the collision.
點擊撥打服務熱線：4008791999
