概述：驅動裝置的作用是驅動混凝土貯罐轉動，它由取力器、萬向軸、液壓泵、液壓馬達、操縱閥、液壓油箱及冷卻裝置組成。如果這部分因故障停止工作
驅動裝置的作用是驅動混凝土貯罐轉動，它由取力器、萬向軸、液壓泵、液壓馬達、操縱閥、液壓油箱及冷卻裝置組成。如果這部分因故障停止工作，自動混凝土攪拌車將不能轉動，這會(huì )導致車內混凝土報廢，嚴重的甚使整罐混凝土凝結在罐內，造成自動上料混凝土攪拌車報廢。因此，驅動裝置是否可靠是使用中須高度重視的問題。為保證驅動裝置完好可靠，應做好以下維護工作：
The driving device is used to drive the concrete storage tank to rotate. It is composed of power take-off, universal shaft, hydraulic pump, hydraulic motor, control valve, hydraulic oil tank and cooling device. If this part stops working due to fault, the self feeding concrete mixer will not be able to rotate, which will lead to the scrapping of the concrete in the truck, or even the whole tank of concrete coagulated in the tank, resulting in the scrapping of the automatic feeding concrete mixer. Therefore, whether the driving device is reliable or not is a problem that should be paid great attention to in use. In order to ensure the integrity and reliability of the driving device, the following maintenance work should be done:
1.萬向轉動部分是故障多發部位，應按時加注潤滑脂，并經常檢查磨損情況，及時修理更換。車隊應有備用的萬向軸總成，以保證一旦發生故障能在幾十分鐘內恢復工作。
1. The universal rotating part is the fault prone part, it should be filled with grease on time, and the wear condition should be checked frequently, and it should be repaired and replaced in time. The team should have a spare cardan shaft assembly to ensure that it can resume work within dozens of minutes in case of failure.
2.保證液壓油清潔。自動上料混凝土攪拌車工作環境惡劣，一定要防止污水泥沙進入液壓系統。液壓油要按使用手冊要求定期更換。一旦檢查時發現液壓油中混入水或泥沙，就要立即停機清洗液壓系統、更換液壓油。
2. Make sure the hydraulic oil is clean. The working environment of the automatic feeding concrete mixer is bad, so the dirty cement sand must be prevented from entering the hydraulic system. The hydraulic oil should be changed regularly according to the manual. Once the hydraulic oil is found to be mixed with water or sediment, it is necessary to stop the machine immediately to clean the hydraulic system and replace the hydraulic oil.
3.保證液壓油冷卻裝置有效。要定時清理液壓油散熱器，避免散熱器被水泥堵塞，檢查散熱器電動風扇運轉是否正常，防止液壓油溫度超標。液壓部分只要保證液壓油清潔，一般故障不多；但生產廠家不同，使用壽命則不一樣。
3. Ensure that the hydraulic oil cooling device is effective. The hydraulic oil radiator should be cleaned regularly to avoid blockage by cement. Check whether the electric fan of the radiator operates normally to prevent the temperature of the hydraulic oil from exceeding the standard. As long as the hydraulic oil is clean, there are few faults in the hydraulic part; However, different manufacturers have different service life.
Thank you for reading, hope the above content is helpful to you, if you want to know more wonderful content, please click our official website: automatic mixer http://m.jackpetty.net .
點擊撥打服務熱線：4008791999
