RM新时代官方-首页

　　Automatic feeding mixer is an indispensable equipment in construction, which is mainly used to transport concrete needed in construction. However, due to the corrosion of concrete to steel, it is necessary to clean the equipment after using it. The following small series for you to introduce the automatic feeding mixer cleaning method.

　　1、每次裝料前用水沖洗進料口，使進料口在裝料時保持濕潤；

　　1. Flush the feed port with water before each loading to keep the feeding port moist during loading;

　　2、在裝料的同時向隨自動上料攪拌車自帶的清洗用水水箱中注滿水；

　　2. At the same time of loading, the water tank for cleaning water provided by the automatic feeding mixer is filled with water;
            

　　3、裝料后沖洗進料口，洗凈進料口附近殘留的混凝土；

　　3. After loading, wash the inlet to clean the residual concrete near the inlet;

　　4、到工地卸料后，沖洗出料槽，然后向自動上料攪拌車貯罐內加清洗用水30—40L；在車輛回程時保持貯罐正向慢速轉動；

　　4. After unloading at the construction site, wash the discharge tank, and then add 30-40l cleaning water into the storage tank of the automatic feeding mixer; keep the storage tank rotating slowly in forward direction when the vehicle returns;

　　5、下次裝料前切記放掉自動上料攪拌車貯罐內的污水；

　　5. Before the next loading, remember to discharge the sewage in the tank of the automatic feeding mixer;

　　6、每天收工時要清洗貯罐及進出料口周圍，保證不粘有水泥及混凝土結塊。

　　6. At the end of each day, the storage tank and the area around the material inlet and outlet shall be cleaned to ensure that there is no cement and concrete caking.

　　自動上料攪拌車的清洗方法就介紹到這里了，以上這些工作只要一次不認真進行，就會給以后的工作帶來很大的麻煩，所以希望大家重視自動上料攪拌車的清洗。如您想要了解更多歡迎點擊http://m.jackpetty.net網站。

　　The cleaning method of automatic feeding mixer is introduced here. If the above work is not carried out seriously once, it will bring great trouble to the future work. Therefore, we hope that we can pay attention to the cleaning of automatic feeding mixer. If you want to know more, please click http://m.jackpetty.net Website.